Table of Contents
Advertisement
Remote Control
ON•OFF
VCR
1
AUX
DVD
VCR
2
Light
MUTE
A
AUTO SET
GUIDE
OK
MENU
2
1
4
5
7
8
INPUT
0
REVERSE
PLAY
RECORD
STOP
REPEAT AUDIO ANGLE OPEN
DVD
u n i v e r s a l
12
Using Direct Entry
1. Turn on the component you want the remote to operate.
MONITOR
2. Look up the brand and code number(s) for the component on the
code list on the following pages.
SAT•CABLE
3. Press and hold the component button that corresponds to the
component you want the remote to operate (VCR, RCA DVD, etc.).
CINEMA
(The light on the remote comes on.)
4. Enter the code from the code list. When you begin entering
numbers, the light on the remote turns off. When the last number is
entered, the light turns back on. If the incorrect code is entered, the
light will flash.
GO BACK
5. Release the component button. The light on the remote turns off.
INFO
6. Press ON•OFF to see if the component responds to the remote
commands. If it doesn't, try pressing the component button and
then ON•OFF again.
7. If you get no response, repeat these steps using the next code listed
for your brand, until the component responds to the remote
CLEAR
commands.
3
6
How To Use the Remote Control After You've
9
Programmed It
ANTENNA
Once the remote control has been programmed successfully, you're
ready to use it to operate other components.
FORWARD
1. Press and release INPUT until the desired input is displayed.
PAUSE
2. Press the component button (MONITOR, VCR, DVD, AUX, or
SAT•CABLE) to operate the component.
3. Press ON•OFF to turn the component on or off.
NOTE: If you keep pressing buttons and nothing happens, you may
have the wrong video source or wrong component selected. You
must select the correct video source and the component button that
matches the component you want to operate.
Advertisement
Table of Contents
