Table of Contents
Advertisement
Setup and connections
U
D
E
SING
IRECT
NTRY
1. Turn on the component you want the remote to operate (the red light
on the remote turns on).
2. Look up the brand and code number(s) for the component on the code
list on the following pages.
3. Press and hold the component button that corresponds to the
component you want the remote to operate (VCR, DVD, etc.).
4. Enter the code from the code list. When you begin entering numbers,
the red light on the remote turns off. When the last number is entered,
the red light turns back on. If the incorrect code is entered, the red
light will flash.
5. Release the component button. The red light on the remote turns off.
6. Press ON•OFF to see if the component responds to the remote
commands. If it doesn't, try pressing the component button and then
ON•OFF again.
6. If you get no response, repeat these steps using the next code listed for
your brand, until the component responds to the remote commands.
H
T
U
OW
O
SE THE
P
I
ROGRAMMED
T
Once the remote control has been programmed successfully, you're ready
to use it to operate other components.
1. Press one of the video source buttons to select a component (VIDEO or
RGB) to operate.
2. Press the component button (MONITOR, VCR, DVD, AUX, or HD
RCVR) to use the Transport buttons (REVERSE, PLAY, FORWARD,
STOP, PAUSE, and RECORD) to operate the component.
3. Press ON•OFF to turn the component on or off.
NOTE: If you keep pressing buttons and nothing happens, you may
have the wrong video source or wrong component selected. You must
press the correct video source and the component button that matches
the component you want to operate.
R
C
EMOTE
ONTROL
A
Y
'
FTER
OU
VE
17
Advertisement
Table of Contents
