Table of Contents
Advertisement
SETUP AND CONNECTIONS
USING DIRECT ENTRY
1.
Turn on the component
you want the remote to operate
(the red light
on the remote turns on).
2.
Look up the brand and code number(s)
for the component
on the code
list on the following
pages.
3.
Press and hold the component
button that corresponds
to the
component
you want the remote to operate (VCR, DVD,
etc.).
4,
Enter the code from the code list. When you begin entering
numbers,
the red light on the remote turns off. When the last number
is entered,
the red light turns back on. If the incorrect
code is entered,
the red
light will flash.
5.
Release the component
button.
The red light on the remote turns off.
6.
Press ON ° OFF to see if the component
responds to the remote
commands.
If it doesn't, try pressing the component
button and then
ON°OFF
again.
6.
If you get no response, repeat these steps using the next code listed for
your brand, until the component
responds to the remote commands.
How To
USE THE REMOTE CONTROL AFTER YOU'VE
PROGRAMMED IT
Once the remote control
has been programmed
successfully,
you're
ready
to use it to operate other components.
1,
2.
Press one of the video source buttons to select a component (VIDEO or
RGB) to operate.
Pressthe component button (MONITOR, VCR, DVD, AUX, or HD
RCVR) to use the Transport buttons (REVERSE,PLAY, FORWARD,
STOP, PAUSE, and RECORD) to operate the component.
3.
Press ON • OFF to turn the component
on or off.
NOTE: If you keep pressing buttons
and nothing
happens, you may
have the wrong
video source or wrong component
selected.
You must
press the correct
video source and the component
button
that matches
the component
you want to operate.
17
Advertisement
Table of Contents
