Table of Contents
Advertisement
Connection to AV components
(continued)
Connection of G with SYNC analog RGB source
Make G with SYNC connections for a component with
output that has the synchronization signal combined with
the green signal.
When connecting to INPUT1
INPUT1
OUTPUT
ANALOG RGB
(ANALOG RGB)
On screen setup is necessary after connection.
Please see pages 25-26.
When connecting to INPUT2
INPUT2
(ON SYNC)
(H/V SYNC)
G
B
R
HD
Use the supplied BNC to RCA phono
jack adapters, if necessary.
On screen setup is necessary after connection.
Please see pages 25-26.
Note
When making G with SYNC connections, do not make any
connections to the VD or HD terminals. If connections are made,
the picture may be not displayed normally.
VD
75
2.2
Ô
kΩ
Ω
Installation and Connections
Connection of composite SYNC analog RGB
source
Make composite SYNC connections for a component
with output that has the vertical synchronization signal
combined with the horizontal synchronization signal.
When connecting to INPUT1
INPUT1
OUTPUT
ANALOG RGB
(ANALOG RGB)
On-screen setup is necessary after connection.
Please see pages 25-26.
When connecting to INPUT2
(ON SYNC)
INPUT2
(H/V SYNC)
G
B
R
HD
VD
Use the supplied BNC to RCA phono
jack adapters, if necessary.
When using INPUT2, set the impedance selector switch
to match the output impedance of the connected
component's synchronization signal.
When the output impedance of the component's
synchronization signal is 75 Ω, set this switch to the 75 Ω
position.
On-screen setup is necessary after connection.
Please see pages 25-26.
Note
When making composite SYNC connections, do not connect
anything to the VD terminal. If connected to, the picture may not
be displayed properly.
75
2.2
Ô
Ω
kΩ
17
Advertisement
Table of Contents
