Table of Contents
Advertisement
How to Program the Remote
There are two ways to program the remote control: automatic code search and direct entry.
ON•OFF
VCR
1
DVD
VCR
AUX
2
Light
Component Buttons
These are the buttons you program to operate another
component.
Important: The remote may not be compatible with all
models of all brands of components. It may also not
operate all functions of the remote that came with your
component.
Using Automatic Code Search
1. Turn on the component you want the remote to operate
2. Press and hold the component button that corresponds to
SAT•CABLE
Note: You can also use Automatic Code Search to program the AUX button for
audio components.
3. Press PLAY (the light on the remote starts flashing).
NOTE: If the component doesn't turn off after you've pressed the PLAY button 20
times, the component can't be programmed.
4. Press REVERSE and wait 2 seconds. Repeat this step
5. When the component turns on, press and hold the STOP
(VCR, HD receiver, etc.)
the component you want the remote to operate (VCR,
satellite receiver, etc.). While you hold down the
component button, press and hold ON•OFF (when the
light on the remote turns on, release both buttons).
The remote is searching the first set of component codes
(there are several sets of codes). If the component you
want to operate doesn't turn off automatically after 5
seconds, press PLAY again (the light starts flashing again
as the remote searches through the next set of codes).
Continue pressing PLAY until the component turns off.
until the component turns back on.
button until the light on the remote turns off.
Remote Control
11
Advertisement
Table of Contents
