Table of Contents
Advertisement
Installation of the Unit
Installation using a stand or wall mount bracket
• Please be sure to request installation or mounting of this unit
or the installation bracket by the dealer where purchased.
• When installing, be sure to use the bolts provided with the
stand or installation bracket.
• For details concerning installation, please refer to the
instruction manual provided with the stand or installation
bracket.
Installation using accessories other than the
stand or installation bracket (sold separately)
• When possible, please install using parts and accessories
manufactured by Thomson. Thomson will not be held
responsible for accident or damage caused by the use of parts
and accessories manufactured by other companies.
• For custom installation, please consult the dealer where the
unit was purchased.
Note for U.S. customers:
If you prefer, we can provide you with the name of an Authorized
Service Representative who will visit your home for a fee to
install your electronic entertainment system and to instruct you
in its operation. For details about this service, call
1-888-206-3359.
For additional assistance while using your RCA Scenium product,
please visit www.rcascenium.com/customersupport.
a hole
b hole
CAUTION
This monitor unit weighs approximately 90 lbs (41 kg) and has little front-to-back depth, making it very unstable when stood
on edge. As a result, two or more persons should cooperate when unpacking, moving, or installing the monitor.
CAUTION
This unit incorporates a thin design. To ensure safety if vibrated or shaken, please be sure to take measures to prevent the
unit from tipping over.
Air vents (fan)
a hole
Center line
Rear view diagram
Installation and Connections
Wall-mount installation of the unit
This unit has been designed with bolt holes for
wall-mount installation, etc.. The installation holes that
can be used are shown in the diagram below.
• Be sure to attach in 4 or more locations above and
below, left and right of the center line.
• Use bolts that are long enough to be inserted 1/2 inch
(12 mm) to 11/16 inch (18 mm) into the main unit from
the attaching surface for both a holes and b holes.
Refer to the side view diagram below.
• As this unit is constructed with glass, be sure to install
it on a flat, unwarped surface.
CAUTION
To avoid malfunction, overheating of this unit, and possible fire
hazard, make sure that the vents on the main unit are not
blocked when installing. Also, as hot air is expelled from the air
vents, be careful of deterioration and dirt build up on rear surface
wall, etc.
CAUTION
Please be sure to use an M8 (Pitch = 1.25 mm) bolt. (Only this
size bolt can be used.)
Main unit
Center line
b hole
1/2 inch (12 mm) to
11/16 inch (18 mm)
Attaching surface
Installation
bracket, etc..
a hole
Bolt
1/2 inches (12 mm) to
11/16 inches (18 mm)
Bolt
b hole
Side view diagram
15
Advertisement
Table of Contents
