Table of Contents
Advertisement
Using
the
Romote
Control
Important
note for direct entry
You must continue
pressing
the component
button
while you enter the code.
Let's say you have a Zenith
VCR. To program
the universal remote
to operate
the VCR, you
would:
Press and hold the VCR button
while you en-
ter the first code listed for Zenith
in the VCR
Codes column.
Release the VCR button.
Press ON,OFF to see
if the VCR responds. If it doesn't,
follow
the
same steps, but enter the second code for
Zenith
VCRs instead of the first.
Using Direct Entry
1.
Turn on the component
to be programmed.
2.
Look up the brand and code number(s)
for the component
on the code list
in this section.
3.
Press and hold the component
button you want to program
on the remote.
4.
Enter lhe code from the remote control code list on lhe following pages. If
lhe indicator flashes, you have either entered
an invalid code or the button
isn't programmable.
5.
Release the component
button, point the remote at the component
and
lllen press ON-OFF
to see if the component
responds
to the command.
If it
doesn't,
try pressing the component
button and lllen ON* OFF again.
*
If you get no response,
repeat these steps using llle next code listed for
your brand, until llle component
responds
to the remote commands.
*
If you fry all tile codes tbr your component
brand and none work, try the
automatic
code search method. If automatic
code search doesn't find the
code, the remote is not compalible
wilh your component.
ComponentButtons
f
ii)i)i_ii,'_!i,)!i_))i
_
©
Note
Some of the remote's
buttons
might
operate
differently
for other components,
especially
when you're using another
component's
menu
system.
How to Use the Remote After You've Programmed
It
Because
this
universal
remote
can
control
several
different
components
('IV,
DVD, VCR, satellite receiver, etc.) it uses operational
modes triggered by the
component
buttons. For exmnple, if you want the remote to operate the TV,
you would press the "IV button to
put
|he remote into TV mode before you
could control the TV.
1.
Press the appropriate
component
button (DVD, TV, VCR, SAT/CAB,
AUX/HD, AUDIO) to set the remote to conlrol the component.
2.
Press ON*OFF to turn the component
ON or OFF.
.
Use the remote buttons
that apply to that component.
"II_e component
button on your remote lights up when you press valid buttons while in that
component's
mode.
Notes:
The remote may not be compatible
with all brands and models of
components.
It also may not operate
all functions
of the remote that
came with your component.
If you keep pressing buttons
and nothing
happens, the remote
is
probably
in the wrong mode. You must press the component
button
that matches the component
you want to operate
(i.e., if you want to
operate
the VCR, press VCR on the remote control
to put the remote
in VCR mode.)
Using the INPUT Button
)
Use the INt UT button to scroll through the available input channels
and view
components
you have connected
to the TV.
1.
Press TV to place the remote in TV mode. Make sure the component
you
want to view is turned ON.
2.
Press INPUT until you reach the correct input channel.
3.
To return to the channel you were previously watching
on TV, press CH+
or CH- button.
Chapter
2
Graphics contained_ u_ithin this publication
are fi)r representation_
_ _
only.
21
Advertisement
Table of Contents
