Table of Contents
Advertisement
Remote Control
Installing the batteries
POWER
STANDBY/ON
CAUTION
• Insert batteries so that the plus (+) and minus (–)
sides are aligned according to the markings in the
battery case.
• Do not mix new batteries with used ones.
• The voltage of batteries may differ even if they are
the same shape. Please do not mix different kinds
of batteries.
• When not using the remote control unit for a long
period of time (1 month or more), remove the
batteries from the remote control unit to prevent
leaking of battery fluid. If battery liquid has leaked,
thoroughly wipe the inside of the case until all liquid
is removed, and then insert new batteries.
• Do not charge, short, disassemble or throw the
provided batteries in a fire.
• When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction's rules that apply in your country or
area.
10
Using Your Remote Control
Inserting Batteries
1. Remove the battery compartment cover from the remote
2. Insert batteries (included) as shown on the diagram inside
3. Replace the battery compartment cover.
Use your remote control from a distance of about 7m/23 feet
from the monitor's remote control sensor and at a horizontal
angle of within 30°. The remote operates on line of sight, so if
there is anything blocking the path between the remote and the
remote control sensor on the front of the monitor, the remote
may not work.
•
•
•
•
INPUT
CINEMA
– VOLUME +
Programming the Remote
Approx.
7m/23 ft.
The universal remote control that came with your monitor is
30°
30°
already programmed to operate most RCA, GE, and Proscan
VCRs, DVD players, laserdisc players, audio receivers, and
VCR1
ON OFF
MONITO R
DVD
VCR2
AUX
SA T CABLE
MUTE
WH O
satellite receivers. This remote is also capable of operating
SLEEP
GO BACK
GUIDE
INFO
OK
many other brands of remote-controllable electronic
MENU
CLEA R
1
2
3
4
5
6
7
8
9
INPU T
ANTENNA
0
components, but you must program it to do so.
REVERS E
PLAY
FORW ARD
RECORD
STO P
P AUS E
CINEMA VGA
Y u v
VIDE O
SOURCE
Find Out If You Need to Program
the Remote
To determine whether the universal remote needs to be
programmed, turn on one of your components, such as a VCR.
Point the remote control at the component and press the
component button (for example, the VCR button). Now press
the ON•OFF button on the remote. If the component doesn't
turn off, you need to program the remote control in order for it
to operate that component.
control.
the battery compartment.
Don't expose the remote control sensor on the front of the
monitor to direct sunlight or strong artificial light.
Don't get the remote control wet.
Avoid heat and humidity.
When not using the remote for a long period of time,
remove the batteries.
When handling the remote control unit
• Do not drop or shake the remote control.
• Do not use the remote control unit in a location
subject to direct sunlight, heat radiation from a
heater, or in a place subject to excessive
humidity.
• When the remote control unit's batteries begin
to wear out, the operable distance will gradually
become shorter. When this occurs, replace all
batteries with new ones as soon as possible.
Advertisement
Table of Contents
