Pro-Form Whirlwind PRO User Manual page 38

10. Identify the Right Handlebar (7) and the Right
Handlebar Base (8). Orient these parts so
that the wide side of the tube on the Right
Handlebar and the Right Link Arm (15) are on
the same side.
Attach the Right Handlebar (7) to the Right
Handlebar Base (8) with two M6 x 38mm Bolts
(57) and two M6 Locknuts (56). Make sure that
the Locknuts are in the hexagonal holes.
Attach the Left Handlebar (not shown) to the Left
Handlebar Base (not shown) in the same way.
10
Wide Side of
the
.'_56
57_/_ I _'_ Hexagonal
Holes
11. Apply grease to two Wave Washers (78). Slide
a Wave Washer onto each end of the Handlebar
Axle (33).
Next, slide the Right and Left Handlebars (7, 9)
onto the Handlebar Axle (33). Make sure that
each Handlebar is on the correct side.
Then, tighten an M8 x 16mm Screw (84), an Axle
Cover (49), and an M8 Washer (85) into each
end of the Handlebar Axle (33) at the same
time.
11
49
85
33
84
49
10