Error Messages - Lenovo ThinkPad X200 Hardware Maintenance Manual

Table 2. Numeric error codes (continued)
Symptom or error
2110
Read error on HDD0 (Main hard disk drive)
2112
Read error on HDD1 (Ultrabay hard disk drive)

Error messages

Table 3. Error messages
Symptom or error
Device address conflict.
Allocation error for device.
Failing bits: nnnn.
Invalid system configuration data.
I/O device IRQ conflict.
Hibernation error.
Fan error.
Thermal sensing error.
Cannot boot from any device.
Downloaded from LpManual.com Manuals
FRU or action, in sequence
1. Reseat the hard disk drive.
2. Main hard disk drive.
3. System board.
1. Reseat the hard disk drive.
2. Ultrabay hard disk drive.
3. System board.
FRU or action, in sequence
1. Load "Setup Defaults" in the BIOS Setup Utility.
2. Backup battery.
3. System board.
1. Load "Setup Defaults" in the BIOS Setup Utility.
2. Backup battery.
3. System board.
1. DIMM.
2. System board.
1. DIMM.
2. System board.
1. Load "Setup Defaults" in the BIOS Setup Utility.
2. Backup battery.
3. System board.
1. Restore the system configuration to what it was
before the computer entered hibernation mode.
2. If memory size has been changed, re-create the
hibernation file.
1. Fan.
2. Thermal grease.
3. System board.
System board.
Check the status of device which you want to boot
from.
Device not found.
1. The device you want to boot from.
2. System board.
Device Error.
1. The device you want to boot from.
2. System board.
No valid operating system.
1. Check that the operating system has no failure and is
installed correctly.
2. Reinstall the operation system.
Excluded from boot order.
• Enter the BIOS Setup Utility and add the device in boot
order.
.
Chapter 4 Related service information
55