Lenovo ThinkPad X200 Hardware Maintenance Manual page 60

Table 2. Numeric error codes (continued)
Symptom or error
1810
Hard disk partition layout error.
1820
More than one external fingerprint reader is attached.
Power off and remove all but the reader that you set up
within your main operating system.
1830
Invalid memory configuration—Power off and install a
memory module to Slot-0 or the lower slot.
2000
Hard Drive Active Protection sensor diagnostics failed.
Press <Esc> to continue. Press <F1> to enter SETUP
2010
Warning: Your internal hard disk drive (HDD) may not
function correctly on this system. Ensure that your HDD
is supported on this system and that the latest HDD
firmware is installed.
201x
The solid state drive you have installed has not passed
qualification for use in this computer. Using this drive may
cause compatibility issues and potential issues with data
integrity, including data loss. Press <Esc> to continue.
2100
Initialization error on HDD0 (Main hard disk drive)
2102
Initialization error on HDD1 (Ultrabay hard disk drive)
54
Hardware Maintenance Manual
Downloaded from LpManual.com Manuals
FRU or action, in sequence
1. If the Access Predesktop Area has been previously
disabled, then go to the BIOS Setup Utility by
pressing F1 to open the BIOS Setup Utility. Select
Security ➙ Predesktop Area ➙ Access Predesktop
➙ Area. Set this item to Disabled. Save and exit.
2. If the Access Predesktop Area has not been
previously disabled, press Enter to load Access
Predesktop Area. Then run RECOVER TO FACTORY
CONTENTS in Access Predesktop Area.
3. If item 2 failed, press F3 in the Welcome screen in
RECOVER TO FACTORY CONTENTS. Run FDISK,
and then delete all partitions. Run RECOVER TO
FACTORY CONTENTS in Access Predesktop Area
again.
4. If item 3 failed, select CD-ROM boot in Startup in
Access Predesktop Area. Boot from the Recovery
CD and perform full recovery from it.
5. If item 4 failed, replace the hard disk drive.
Remove all but the reader that you set up for the
authentication.
Install DIMM in Slot-0, but not in Slot-1.
Note: For the construction of the DIMM slot, see "1030
DIMM" on page 74.
1. Undock docking station or port replicator if it is
attached to the ThinkPad Notebook.
2. Place the ThinkPad Notebook on a horizontal surface.
Do not apply any physical shock to the computer.
3. Run Diagnostics ➙ ThinkPad Devices ➙ HDD
Active Protection Test.
Inform the following information to the customer: If in
the primary bay the customer is using a non-Lenovo
hard disk drive (HDD), with the risk in mind, the customer
can still use it by pressing ESC. If in the primary drive
bay the customer is using a supported Lenovo HDD
with an old firmware, the customer needs to update its
firmware to the latest. The latest version is available at
http://support.lenovo.com
Inform the following information to the customer: If the
customer is using a non qualified SSD which is not
supported by this system, with the risk in mind, the
customer can still use it by pressing ESC. Location of the
SSD is designated as below:
2010: HDD0 (in HDD slot-0)
2011: HDD1 (in HDD slot-1)
2012: Ultrabay with HDD adapter
1. Reseat the hard disk drive.
2. Main hard disk drive.
3. System board.
1. Reseat the hard disk drive.
2. Ultrabay™ hard disk drive.
3. System board.