Silicon Laboratories Biometric EXP EVB UG User Manual page 17

Upon completion of the steps above you should have a working project in Simplicity Studio that can be built and
debugged.
10. To build the demo, simply click on the
configurations: Release and Debug. You can select between the two by clicking the down arrow next to
the Hammer icon.
11. To debug the project, select the Debug build configuration then click on the
IDE. A debug session will automatically launch and if a board is connected, the project will be loaded into
the MCU.
Figure 16. Symbolic Link to the Lib Folder
icon in the Simplicity IDE. Note that there are two build
Rev. 0.1
Biometric EXP EVB UG
icon in the Simplicity
17