Charging - Samsung SR8980 User Manual

Charging

When the product is initially purchased, the battery is fully
discharged, and you must Charger (station) the Robot
vacuum manually.
1. After aligning the Charger (station) pins of the
main unit with the Charger (station) pin of the
Charger (station), press the main unit until you hear
"recharging is now starting" sound.
- The Charging Lamp turns green.
2. Check the Charger (station) status of the Robot vacuum.
- When charging starts, "the amount of remaining battery power"
and "
sequence.
- When charging is complete, the battery level indicator and
"FULL" will be displayed in the display panel.
■ When the battery level display flashes while cleaning,
Flash
the Robot vacuum stops vacuuming and automatically
charges itself at the charger.
■ If the Robot vacuum starts the current cleaning run at a
location other than the charging station and fails to locate
the charging station while cleaning, it will stop near the
location where it started cleaning.
Flash
■ When the battery level flashes and "Lo" is displayed
while cleaning, Robot vacuum cannot be operated by
the remote control or the buttons on the main unit. In this
case, directly carry the Robot vacuum to the charger to
charge the battery. (This is when the battery is completely
discharged.)
24_ operating
Turn on the Power Switch at the bottom of the product.
" are displayed on the status display panel in this
Power lamp
Power lamp
Charging
<Charge display>
Charge
complete
Charging lamp
Charging lamp
Fully charged
Charging Required
charging