Table of Contents
Advertisement
Maintenance
WARNING!
Potential hazard that could result in serious injury or loss of life.
•
Unplug the welder before performing any maintenance or service.
•
Only use the welder after replacing or repairing any damaged parts or
accessories.
•
Use only recommended and properly rated replacement parts. Failure to
comply could lead to serious injury or loss of life.
MAINTENANCE
REQUIRED
In-depth inspection
Repair or replacement
The welder needs regular maintenance as following:
•
Clean the dust, dirt, and grease periodically from the welder.
•
Every six months, remove the front panel from the welder to clear the accumulated dust and
dirt.
•
Replace power cord, ground cable, ground clamp or electrode assembly when damaged or
worn.
•
Repairs must be performed by a qualified service technician only.
Storage
•
Store the welder in a clean and dry location away from corrosive gas and excess dust at a
temperature of -12°C-48°C (10°F-120°F) and relative humidity of less than 90%.
•
It is recommended to repack the welder when transporting or storing the welder after use.
•
Cleaning is required before storage.
MAXIMUM SERVICE INTERVAL
DESCRIPTION
Monthly
Worn or broken parts
Worn or broken parts
MIG 180 INVERTER WELDER 058-9306-4
As Needed
X
X
X
42
Hide quick links:
Advertisement
Table of Contents
