MasterCraft MIG 180 Instruction Manual page 28

16. Turn ON the primary power switch (1) on
the back panel of the welding unit
(fig 1T)
. Refer to MIG welding operation
page 30.
Installing the wire roller
1. Open the wire drive compartment.
2. Remove the drive tension by loosening
the drive tension adjusting knob (1) and
lifting the drive tension adjustor and
drive tension arm (2) away from the
(fig 1U)
drive roll (3)
Note: Proper sized drive roll must be used
before installing the wire.
3. Insert the end of the wire (1) into the hole
on outside edge of the wire spool and
bend the wire to hold the wire in place.
Remove the wire spool from the wire
drive compartment
Note: If the wire is already installed in the
welder, roll the wire back onto the wire spool
by manually rotating the wire spool clockwise.
Do not allow the wire to come out of rear end
of the inlet guide tube.
.
(fig 1V).
MIG 180 INVERTER WELDER 058-9306-4
fig 1T
POWER
PUISSANCE
ON
MARCHE
OFF
ARRÊT
／ 0589306 GAS INPUT
ENTRÊE DE GAZ
NORMAL
MIG STICK OVER CURRENT
GAZ INERTE ARC
NORMAL
160 A 140 A
OCV 78Vdc OCV 78Vdc
22 V 25.6 V
230 V AC, 30 A max
fig 1U
2
fig 1V
1
1PH
220V ~ 240V
MC-589306-29
1
3
MC-589306-30
1
MC-589306-31
24