MasterCraft MIG 180 Instruction Manual page 48

PROBLEM POSSIBLE CAUSES
1. Not enough drive roll pressure.
2. Spool hub tension too tight or
Inconsistent arc or
3. Contact tip worn or wrong size.
wire feed.
4. Rusty or corroded wire.
5. Electrode or damaged flux is too
Note: For further assistance on installation and repairs, please contact 1-800-689-9928.
loose.
big.
MIG 180 INVERTER WELDER 058-9306-4
SOLUTIONS
1. Tighten the drive tension adjustor on wire
feeder.
2. Adjust the wing nut on the spool holder.
3. Replace the contact tip.
4. Replace the wire.
5. Use correct or undamaged electrode.
44