MasterCraft MIG 180 Instruction Manual page 11

7
Risk of UV and IR arc rays: Do not look at the welding arc without proper eye
•
protection, as the welding arc produces ultraviolet (UV) and infrared (IR) rays.
Use shields that adheres to ANSI Z87.1. For welders under 160 A output, use a
shade 10 lens; for above 160 A, use a shade 12 lens. Wear flame retardant
clothes, leather shirts, pants or shoes to cover the bare skin from the arc.
• Use appropriate shield to prevent other personnel from being affected by
harmful rays.
Risk of electromagnetic fields: Electromagnetic field can damage electrical
•
and electronic devices like pacemakers and hearing aids. Make sure people
using pacemakers are away from your welding area when welding. Always
wrap the MIG gun and ground cable together.
WARNING!
Potential hazard that could result in serious injury or loss of life.
Do not allow unskilled or untrained individuals to install and operate this
•
welder.
• Keep hands and fingers away from moving parts such as drive roll or fan
while the welder is in use.
• Before operating the welder, check the insulation of the ground cable, power
cord, and welding cable for damage. Replace or repair the damaged
components before using the welder. Use only recommended parts for
replacement.
• Avoid contacting or touching welding wire, work piece, ground connection or
electrode from another welder.
• Do not drape cables over or around the body.
• Do not point the MIG gun toward yourself or other personnel.
• Consult a doctor before using the electric arc welder.
• Always have a secure stance while welding to prevent accident.
• Do not use this welder when you are tired or under influence of alcohol or
drugs.
• Connect the ground lead close to the work area to ensure proper ground
connection.
• Always secure the high pressure cylinder upright to a cart or stationary
object.
• Do not use a welder to thaw frozen pipes.
• Do not look into the valve of the high pressure cylinder when opening it.
MIG 180 INVERTER WELDER 058-9306-4