Table of Contents
Advertisement
29
Setting the wire tension
1. Press the trigger on the gun.
2. Turn the drive tension adjustment knob
(1) clockwise, and increase the drive
tension until the wire feeds smoothly
without slipping
3. Apply slight back pressure against the
wire by curling the wire. If wire
continues to feed smoothly, the wire
tension is set correctly.
WARNING!
Potential hazard that could result in serious injury or loss of life.
•
To reduce the risk of arc flash, ensure that wire passing out of the end of
the torch does not contact with the work piece, ground clamp or any
grounded material during the drive tension setting process. If not followed,
arcing will occur.
•
Do not apply back pressure on the wire without a glove. Failure to comply
may result in injury.
(fig 2D)
.
MIG 180 INVERTER WELDER 058-9306-4
fig 2D
2
1
1
MIG
SPOOL GUN/PISTOLET À BOBINE
-
-
MC-589306-39
Hide quick links:
Advertisement
Table of Contents
