Table of Contents
Advertisement
27
Maintenance
MAINTENANCE
REQUIRED
In
depth inspection
-
Replace worn or
broken parts
The welder needs regular maintenance as following:
•
Clean the dust, dirt, and grease periodically from the welder.
•
Every six months, remove the front panel from the welder to clear the accumulated dust and dirt.
•
Replace power cord, ground cable, ground clamp, or electrode assembly when damaged or
worn.
•
Repairs must be performed by a qualified service technician only.
Storage
•
Store the welder in a clean and dry location away from corrosive gas and excess dust at a
temperature of 10° F
•
It is recommended to repack the welder when transporting or storing the welder after use.
•
Cleaning is required before storage.
WARNING!
Potential hazard that could result in serious injury or loss of life.
•
Unplug the welder before performing any maintenance or service.
•
Only use the welder after replacing or repairing any damaged parts or
accessories.
•
Use only recommended and properly rated replacement parts. Failure to
comply could lead to serious injury or loss of life.
DESCRIPTION
Worn or broken
parts
120° F and relative humidity of less than 90%.
-
FLUX-CORE WIRE FEED WELDER KIT 058-8194-4
MAXIMUM SERVICE INTERVAL
TOOLS OR
MATERIALS
Each Use or
REQUIRED
every 2 Hrs
As
Monthly
Needed
X
X
X
Hide quick links:
Advertisement
Table of Contents
