Advertisement
Quick Links
120 V.A.C. 12 AMP. 60 Hz.
Double Insulated
20" Clearing Width
ELECTRIC SNOW THROWER
MODEL NO.
536.882091
Caution:
Read and follow all Safety
Rules and Operating
Instructions
before first use
of this product.
:(_
LISTED
SNOW THROWER
©_L.,J
NO. 894Y
SEARS,
ROEBUCK
AND CO., Hoffman
Estates,
IL 60179
U.S.A.
F001021M
08/30199
Advertisement
Related Manuals for Craftsman 536.882091
Summary of Contents for Craftsman 536.882091
- Page 1 120 V.A.C. 12 AMP. 60 Hz. Double Insulated 20" Clearing Width ELECTRIC SNOW THROWER MODEL NO. 536.882091 Caution: Read and follow all Safety Rules and Operating Instructions before first use of this product. LISTED SNOW THROWER ©_L.,J NO. 894Y SEARS, ROEBUCK AND CO., Hoffman Estates,...
- Page 2 ON CRAFTSMAN SNOW THROWER For one year from the date of purchase, when this Craftsman Snow Thrower is main- tained, lubricated, and tuned up according to the operating and maintenance instruc- tions in the owner's manual, Craftsman will repair, free of charge, any defect in mate-...
-
Page 3: Operating Safety
• Never operate the snow thrower at high • Check shear bolts and other bolts frequently transport speeds on slippery surfaces. Look for proper tightness to be sure the snow behind and use care when backing. thrower is in safe working condition. •... -
Page 4: Tools Required
WARNING: Look for this symbod to point • Never attempt to make any adjustments while out important safety precautions. It means---At- the engine (motor) is running (except when tention!!! Become alerti!! Your safety is involved. specifically recommended by the manufac- turer). - Page 5 • Remove cotter pin, flatwasher and wave • Place cotter pin through worm end of washer from the worm end of chute chute control rod. control rod and set aside (see figure • Bend cotter pin to secure. below). • Rotate the chute control rod fully clock- •...
- Page 6 IMPORTANT: Use a U.L. listed two con- ductor extension cord suitable for outdoor use in cold weather. Extension cord should be no longer than 100 feet. Extensions cords are available at Craftsman Service Centers. RECOMMENDED EXTENSION CORDS TO USE AUGER...
- Page 7 Q For most efficient snow throwing, turn the • Snap strain relief clip down over loop of discharge chute deflector to threw snow cord, see figure below. Connect exten- downwind, and slightly overlap each sion cord to power plug on control switch. swath.
- Page 8 packed s now iscausing t he required to remove snow of this type than auger to slow level snow. down and the chute to clog, back off and begin a series of short jabs into the snow. PRODUCT SPECIFICATIONS These short back and forth, 4 to 6 inch, jabbing motions will "belch"...
- Page 9 The drive belt on this unit is of special con- struction and must be replaced with the , Belt same type belt available at your nearest Auger Cover Craftsman Service Center. Pulley Location • Remove the belt cover (see to Remove TO ADJUST THE DRIVE BELT the Belt Cover paragraph on this page).
- Page 10 NOTE: A yearly checkup or tune-up at a Craftsman Service Center is a good way of ensuring that your snow thrower will provide maximum performance for the next season.
- Page 11 If the motor stops, release the control bar, disconnect the ex tension cord and allow the motor to cool 5 minutes before continuing operation. If this happens often take your snow thrower to an autho fized Craftsman Service Center for repair and adjustment.