Table of Contents
Advertisement
Start-up
When I apply power to the track my
engine doesn't do anything. No lights, no
sound.
Sound
I have no sound on my engine, but my
lights are on and it moves just fine.
There's a crackling sound from my
engine.
When I run Doppler I can hear the
Doppler shift but then the engine sounds
fade out and I can't get them back.
DCC
Did you press F3 yet? F3 on your DCC
handheld will start your engine up.
Check to see if that section of track has
power. Use a voltmeter or a lit passenger car,
not your tongue.
Slide the engine a couple of feet in either
direction, you may have a bad track section.
Have you got that section electrically isolated
with a toggle switch or other device?
Check that you have the Panto/Track switch in
the correct position for your operating
environment
You may have it turned off. Repeatedly press
F6 to cycle through the volume levels (there
are 9 levels, 0-max).
Check to see if a screw or some other
material has lodged itself in the underside of
the engine.
This is normal. You will need to press the F21
button again to turn Doppler off. Your engine
sounds will now return to normal.
Premier E94 Crocodile Electric Engine
Solution
Solution
49
Advertisement
Table of Contents
