Jumpers On The Internal Courier; Locating Jumpers; Changing Jumper Settings - US Robotics Courier V.Everything Getting Started Manual

Jumpers on the Internal Courier

Locating Jumpers

Your internal Courier V.Everything is set to Plug and Play. You shouldn't
have to change this setting, however, if you have multiple devices
connected to your system, you may need to change the jumper settings to
avoid hardware conflicts.
Jumpers

Changing Jumper Settings

You can add shunts (see figure 8.7) to cover sets of pins on the jumper
blocks (see figure 8.6).
Caution: If you do not have any hardware conflicts, you do not need to
use this section.
7-4
Figure 8.5 Jumpers on the Internal Courier
Courier V.Everything Getting Started Guide