Table 14. At+Wubs Band Selection; Table 15. At+Wwsm Cellular Network Setting - US Robotics Courier USR3500 Getting Started Manual

Getting Started
Table 14. AT+WUBS Band Selection
AT+WUBS Command
AT+WUBS=y, x
Use AT+WWSM to change the cellular network setting of the USR3500. Refer to the
table below for the list of main responses returned.
Table 15. AT+WWSM Cellular Network Setting
AT+WWSM Command
AT+WWSM=0
AT+WWSM=1
AT+WWSM=2,0
AT+WWSM=2,1
AT+WWSM=2,2
Description
Where:
y = Band frequency configuration (bit field) in HEX format.
x = Optional reset parameter (0 means the USR3500 will have to be reset
to start on the specified band(s), and 1 means the band switch is effective
immediately. Note that x=1 is forbidden while in Communication mode and
during the USR3500's initialization.
Refer to the document AT Commands Interface Guide at
http://www.usr.com/support/3500.
Description
GSM Digital Cellular System (GERAN)
Universal Terrestrial Radio Access Network (UTRAN) only
3GPP systems (both GERAN and UTRAN); automatic network
3GPP systems (both GERAN and UTRAN); GERAN preferred
3GPP systems (both GERAN and UTRAN); UTRAN preferred
Rev 1.1
Communicating with the
USR3500
9/22/14 32