Installation - Hisense AUD-18UX4SGKL User And Installation Instructions Manual

·Optimum air distribution is ensured.
·
The air passage is not blocked.
·
Condensate can drain properly.
·
The ceiling is strong enough to bear the weight of
the indoor unit.
·
A false ceiling does not seem to be at an incline.
·
Sufficient clearance for maintenance and servicing
is ensured.(See Fig.3.2.1,Fig3.2.2 )
·
Piping between the indoor and outdoor units is
within the allowable limits.(refer to the installation of
the outdoor unit )
·
The indoor unit, outdoor unit, power supply wiring
and transmission wiring is at least 1 meter away
from televisions and radio, this prevents image
interference and noise in electrical appliances.
(Noise may be generated depending on the
conditions under which the electric wave is
generated, even if a one-meter allowance is
maintained.)
·
Use suspension bolts to install the unit, check
whether or not the ceiling is strong enough to
support the weight of the unit. If there is a risk that
the ceiling is not strong enough, reinforce the ceiling
before installing the unit.
For bottom intake, replace the chamber lid and the
intake-side flange in the procedure listed in fig.
(1) Remove the intake-side flange. Remove the
chamber lid.
(2) Reattach the removed chamber lid in the
orientation shown in FIG, reattach the removed
the intake-side flange in the orientation shown in
Fig. 3.2.3, refer to Fig.3.2.4 for the direction of
the intake-side flange.
Fig. 3.2.3
Fig. 3.2.4
Intake-side flange
(unit:mm)
Filter(invalid for this model)
Chamber lid
Chamber lid
Filter(invalid for
this model)
Intake-side flange
Installation and Maintenance

3.2 Installation

3.3.1 Suspension bolts
(1) Consider the pipe direction, wiring and maintenance
carefully, and choose the proper direction and location
for installation.
(2) Install the suspension bolts as shown in Fig. 3.3
below.
·For the concrete
Screw in
150 to160mm
（100 to150kg）
Concrete
Steel bar
Suspension bolts
(W3/8 or M10)
·For the wooden beam
Wood rib
（ ）
60mm to 90mm
Wooden beam
Fig. 3.3 Fixing the suspension bolts
3.3.2 The position of the suspension bolts and the pipes
(1) Mark the positions of the
positions of the refrigerant pipes and the drain pipes.
(2) The dimension are shown below.
l
m
n
a b c
DC-Inverter type 1207 1170 154
ON/OFF Unitary
937 900 154
type
36
·For the steel beam
" " shaped steel beam
Suspension bolts
(W3/8 or M10)
Nut Round washer
Square washer
Nut
Suspension bolts
suspension bolts
e b
b
a
g
d e f g h i j
447 971 117 1039 170 117 150
447 701 117 1235 170 117 150
18K
, the
Air outlet
Air intake
(Unit:mm)
k l m n
199 13 81 84
199 13 81 84