Control With Mouse - Okina TVI-04 User Manual

1.5 Control with Mouse

1.5.1 Connect Mouse
It supports USB mouse through the port on the rear panel, please refer to Fig.1-4Remote Controller.
Notice: If mouse is not detected or doesn't work, check below steps:
1. Make sure the mouse is connected to the USB mouse port not the USB port
2. try another mouse
1.5.2 System operation by mouse
The structure of the main menu is shown in Fig.1-4 Remote Controller.
In live:
Double-click left button on one camera to be full screen display. Double-click again to return to the previous
screen display.
Click right button to show the control bar at the bottom of the screen as Fig.1-4 Remote Controller. Here are all
control and setup. Click right mouse again to hide the control bar.
In setup:
Click left button to enter. Click right button to cancel setup, or return to the previous.
If want to input the value, move cursor to the blank and click. An input window will appear as Fig.1-5. It
supports digitals, letters and symbols input.
Users can change some value by the wheel, such as time. Move cursor onto the value, and roll the wheel
when the value blinks.
It supports mouse drag. I.e. Set motion detection area: click customized, hold left button and drag to set motion
detection area. Set schedule: hold left button and drag to set schedule time
In playback:
Click left button to choose the options. Click right button to return to live mode.
In backup:
Click left button to choose the options. Click right button to return to previous picture.
In PTZ control:
Click left button to choose the buttons to control the PTZ. Click right button to return to live.
•
Notice: Mouse is the default tool in all the operation below unless Exceptional indication.
Fig. 1-5 Digital Numbers and Letters Input Window
TVD-04 / TVD-08 / TVD-16 / TVD-16-1U User's Manual
9