Table of Contents
Advertisement
Dome Camera Control
Dome Camera Connection & Settings:
•
See section Pin Definition of Alarm I/O & RS-485, and Audio In for RS-485 port pin definition.
•
Refer to the following figure. Connect the R+, R- terminals on the dome camera to the D+, D-
terminals on the RS-485 port by RS-485 cable respectively.
•
To set up dome camera's protocol and ID, press MENU to access the OSD main menu, and
select <Camera Setup>. The available protocols include <DSCP>, <AD422>, <Pelco D>,
<Pelco P>, <Fastrax 2>, <JVC>, <Panasonic_C>, and <Panasonic_N>. The default is
<None>. Note that ID number must match the ID address defined by the dome camera.
•
To configure the RS-485 parameters, select <System Setup> from OSD main menu, and then
select <RS485 Setup>. The default RS-485 settings are 9600 Baud, 8 Data Bits, 1 Stop Bit and
No Parity.
Control Buttons in Dome Camera Control Mode:
1
Set / Go Preset
2
Toggle Hint Screen
3
Go Presets 1~6
4
Enter / Auto
5
ESC
6
Pan / Tilt
Enter Dome Camera
7
Control Mode
8
Focus Near
9
Focus Far
13 Zoom In
10 Iris Close
11 Iris Open
12 Zoom Out
5
Advertisement
Table of Contents
