Okina TVI-04 User Manual page 22

Step2: enable motion alarm, set alarm hold time which means time interval between two adjacent detective
motions. If there is other motion detected during the interval period which is considered continuous
movement; otherwise, it will be considered that those two adjacent detective motions are two different
motion events. Click Trigger button, a dialog box will pop-up:
Step3: the setup steps of motion trigger.
(1)Enable the buzzer if user need this function.
(2)Choose the channel which when event happened to show full screen,
(3)Choose enable transfer e-mail function or not.
(Before enable this function, user need to set-up E-mail transit data. please reference 3.6.3)
(4)Choose the snap shot channel.
After complete the configuration, click ok to finish.
Step4: click Area button, a dialog box will pop-up as Fig 3-19:
Step5: in the Area interface, user can drag slide bar to set the sensitivity value(1-8), the default value is 4.
The higher the value is the higher sensitivity you get. Due to the sensitivity is influenced by color and time
(day or night), user can adjust its value according to the practical conditions; click
area as detection area; click
whether the sensitivity value and motion area are suitable accordingly（refer to following picture）; Click
icon, to save the setting; click
Note: when user drag mouse to set motion detection area, they have to click
set detection area firstly, and then make the operation.
Step6: user can setup all channels with same parameters, tick off "all", then to do relevant setup.
Step7: click "default" button to resort default setting; click "apply" button to save the setting; click "exit"
button to exit current interface.
Fig 3-18 Trigger (motion alarm)
Fig 3-19 motion-area
icon, the set detection area will be cleared; click
icon, exit current interface.
22
TVD-04 / TVD-08 / TVD-16 / TVD-16-1U User's Manual
icon, set the whole
icon, user can test
icon to clear all