Table of Contents
Advertisement
7.1
General Troubleshooting
Table 7.1
General Problems and Suggested Solutions
Problem
Some operating systems do not load in
a computer with a MegaRAID SCSI
320-1 controller.
One of the hard drives in the array fails
often.
Chapter 7
Troubleshooting
This chapter provides troubleshooting information for the MegaRAID
SCSI 320-1 controller. It contains the following sections:
·
Section 7.1, "General Troubleshooting"
·
Section 7.2, "BIOS Boot Error Messages"
·
Section 7.3, "Other BIOS Error Messages"
·
Section 7.4, "Other Potential Problems"
Table 7.1
lists the general problems that can occur, along with suggested
solutions.
Suggested Solution
Check the system BIOS configuration for PCI interrupt
assignments. Make sure some Interrupts are assigned for
PCI.
Initialize the logical drive before installing the operating
system.
Check the drive error counts using Power Console Plus.
(See the MegaRAID Configuration Software Guide for more
information.)
Format the drive.
Rebuild the drive
If the drive continues to fail, replace it with another drive with
the same capacity.
MegaRAID SCSI 320-1 Hardware Guide
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
7-1
Advertisement
Table of Contents
