6.2.6
Step 6: Connect SCSI Devices
Figure 6.7
Installing the MegaRAID SCSI 320-1 Controller
Use SCSI cables to connectSCSI devices to the MegaRAID SCSI 320-1.
The MegaRAID SCSI 320-1 provides two SCSI connectors:
·
J1, the internal high-density 68-pin SCSI connector for Wide (16-bit)
SCSI
·
J7, the external very high-density 68-pin SCSI connector
Use this procedure to connect SCSI devices:
1. Disable termination on any SCSI device that does not sit at the end
of the SCSI bus.
Installation Steps
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Bracket Screw
32-bit Slots
(3.3 V)
64-bit Slots
(5 V)
6-13