Telephone operation
Redial
Each handset and the telephone base stores the last 20 dialed numbers (up
to 30 digits each) on the redial list. The redial entries of each handset and
the telephone base are independent.
Review the redial list
To review the redial list of a cordless handset:
1.
Press REDIAL/
2.
Press
or
at the end of the list.
OFF/
Press
CLEAR
To review the redial list of the telephone base:
Press REDIAL in idle mode.
1.
2.
Press DIR, CID, /DELETE or /REC to browse.
The telephone base beeps twice at the end of the list.
Press CANCEL to exit.
Dial a redial entry
To dial a redial entry of a cordless handset:
1.
Press 1 LINE/
CELL to use the cell line. Then, press REDIAL/
redial list.
2.
Press
or
beeps twice at the end of the list.
3.
Press the DIAL softkey to dial the number displayed.
You can also select a redial entry before dialing.
1.
Press REDIAL/
2.
Press
or
beeps twice at the end of the list.
Press 1 LINE/
3.
CELL to use the cell line.
NOTE: You may also press
speakerphone is determined by the line preference setting. To change the setting, see
page 33.
in idle mode.
PAUSE
to browse. The handset beeps twice
to exit.
or 2 LINE/
FLASH
to browse until the desired number displays. The handset
in idle mode.
PAUSE
to browse until the desired number displays. The handset
or 2 LINE/
FLASH
/SPEAKER to dial a redial entry. The default line for the
to use the corresponding line or
FLASH
to use the corresponding line or
FLASH
80
to enter the
PAUSE