Digital Watchdog VMAX IP 4CH User Manual page 44

Select Motion alarm to record only when motion detection is triggered according to the motion detection settings set in the
NVR's Camera menu option. See 4.2.2 Camera for more information.
When motion is detected, you can setup to activate a relay output or set instant notifications.
To enable:
1. Check the box next to the channels you want to activate for motion detection alarm.
2. Select the notification type from the drop down menu options.
Notify
a. "Beep" – when an alarm is triggered, the NVR will make a beep sound.
b. "Cam pop-up" – when an alarm is triggered, the NVR's live screen will switch automatically to single channel
mode, displaying the camera associated with the alarm.
c. "All" – when an alarm is triggered, the NVR will make a beep sound while the live screen will switch to a single
screen view of the camera associated with the alarm.
3. Relay: enable or disable relay output control when motion is detected.
4. Dwell Time: Set the recording period from the start of sensor input activation. During this period, the corresponding
camera video will record according to the frame and alarm (relay) output set. The recording stops and alarm output is
turned off when the dwell time has elapsed
Copy Settings: You can copy the settings from one sensor input to multiple sensors for easy and quick
5.
configuration. Choose the sensor you want to copy from at the "From" field. Choose the settings you want
to copy by selecting the check box next to each one. Check the checkbox next to the sensor numbers to
apply the copy setting(s) to on the "To" box.
User's Manual | 42