Aruba Networks Access Point Aruba AP 60/61 Installation Manual page 7

Aruba AP60–Two Reverse Polarity SMA (RP-SMA) connectors for attaching
A
separate antennas (not included). For details, see
Antennas" on
ArubaOS 2.2 releases or lower. Single antenna operation is supported with
ArubaOS 2.3 or higher.)
N : When facing the A60 as shown in
OTE
on the left is for antenna 1, and the connector on the right is for
antenna 2 in a diversity configuration.
B Aruba AP61–Built-in swivel array with dual, tri-band, omnidirectional
antennas
2
Indicator LEDs
During operation, the Aruba AP 60/61 LEDs provide the following information:
T 1-1 Aruba AP 60/61 LEDs
ABLE
LED State
PWR Off
A
Green-Solid
B ENET Off
Green-Solid
Green-Flashing
C WLAN Off
Green-Solid
Green-Flashing
N : LEDs on the Mobility Controller provide additional status and security
OTE
information about connected APs.See the ArubaOS User Guide for more
information.
3
Air Vents
These vents promote proper air circulation for cooling the device. Do not allow
these vents to be obstructed by mounting equipment, network cables, or any
other material.
page 22. (The AP60 requires that both connectors be used in
Description
The device is off - no power.
The device is powered and operating.
No link on the FE port. No connection to the
network.
Ethernet link detected on the FE port.
Transmitting or receiving data across the FE
port. Flashing rate is proportional to network
activity.
The wireless interface is disabled or down.
The wireless interface is enabled and
functioning as an Access Point.
The wireless interface is enabled and
functioning as an Air Monitor.
"Aruba 60 Detachable
Figure 1-1, the antenna connector
Aruba AP 60/61
Installation Guide
Introduction
Chapter 1
3