Table of Contents
Advertisement
F
2-2
Port Range Screen
IGURE
5.
Specify the Aruba AP 60/61-specific parameters.
Configure the gain value appropriate for the location in which this AP will be
deployed. (See
N
:
If the AP being provisioned is a model with detachable antenna capability
OTE
(such as an Aruba AP-60), enter the antenna gain in dBi(e.g., 4.0). This is
mandatory for all detachable antenna models as the AP will not bring up
its radio interface or function as an AP without it.
Complete specifying Master Discovery and IP Settings and click
6.
Plug the AP into one of the ports configured for provisioning.
If your AP is already plugged into the port, unplug it and plug it in again. If AP
is connected through POE, enter (in interface mode) no poe followed by poe.
The AP will come up with an IP from the provisioning subnet
After the AP comes up it should be in the provisioning list. Provisioning list
shows the list of APs which are plugged into the provisioning ports.
7.
The Clear Table button appears after an entry in the list appears.
To erase all the table entries, click Clear Table. (You cannot clear selected
entries.) If a number of APs are provisioned and you click Clear Table, only
the entries which come up afterwards can be provisioned.
Table 3-1
for appropriate antenna gain values.)
Provisioning Access Points
Chapter 2
Apply
.
Aruba AP 60/61
Installation Guide
11
Hide quick links:
Advertisement
Table of Contents
