Aruba Networks Access Point Aruba AP 60/61 Installation Manual page 22

Aruba networks access point installation guide
Table of Contents

Advertisement

Provisioning Access Points
Chapter 2
The master and serverip environment variables also affect how
N
:
OTE
source files are selected and should be cleared when using this
approach. To clear a variable, enter the setenv variable command with
no host or address value.
When finished, proceed to Step 2.
My network uses direct IP addresses instead of DNS.
If using direct IP addresses in your network, use the following
commands:
apboot> setenv serverip <Mobility Controller IP address>
apboot> setenv master <Mobility Controller IP address>
If the servername variable is configured in this scenario, it will be
N
:
OTE
ignored.
2.
Specify an IP address for a specific AP , if necessary.
If using DHCP , the AP will obtain its IP address automatically and you can
skip this step. Otherwise, configure the AP with a static IP address using the
following commands:
apboot> setenv ipaddr <static IP address for the AP>
apboot> setenv netmask <static IP address mask>
apboot> setenv gatewayip <default gateway IP address>
3.
Set the location for the specific AP , if necessary.
Location settings depend on how much control you want over configuring
logical groups of APs in the future.
Default Locations
If you wish all APs treated as a single entity for configuration and
accounting purposes, you can use the default location profile
(255.255.65535) and skip to Step 4.
N
:
If using default locations during initial provisioning, you can later
OTE
reconfigure the APs to use specific location IDs using the Aruba
Mobility Controller management tools.
Specific Locations
By setting specific location IDs for each AP , you can later apply
configuration changes or collect statistics and information for specific
groups of APs (for example, all APs on a particular floor in a particular
building).
To set a specific location for an individual AP , the following command is
used:
setenv location <building number>.<floor number>.<device number>
18
Aruba AP 60/61
Installation Guide
0500160
December 2005

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ap 60Ap 61

Table of Contents