First Degree Fitness Fluid Cycle XT E720 Owner's Manual page 15

Tank Belt Adjustment
Step 1: Remove large metal in-
spection plate as shown above
right.
Step 2: Using a long tool, push
out the rear end cap as pictured
right. This will give you access
to the tank tensioning bolt
(shown bottom right).
Step 3: Loosen both the front
and rear tank bolts as shown
below. Remove front rubber belt
cover.
Step 4: Using a 6mm Allen key,
tighten the belt using the tank
tensioning bolt until the belt no
longer slips during hard rowing.
Note: Do not over tighten
tank bolts.
Step 3
15
Step 2
Tip: Twist the belt by hand to gauge tightness.
Correct tension should be obtained when no
longer able to twist more than 45 degrees.
End Cap
Tank tensioning bolt
Step 4