Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Kirisun PT578
Summary of Contents for Kirisun PT578
- Page 1 PT578 FM HANDHELD TRANSCEIVER INSTRUCTION MANUAL...
- Page 2 PT578 FM HANDHELD TRANSCEIVER We are very grateful for your purchasing brand two-way radios produced by Shenzhen Kirisun Electronics Co., Ltd. We believe two-way radio, which always incorporates the latest technology, can bring great convenience to your life and work;...
- Page 3 (where the air contains authorized Kirisun dealer without delay. gas, dust and smog, etc.), such as while taking on fuel, or while parking at a gasoline service station.
-
Page 4: Table Of Contents
1. Unpacking and Checking 2. Preparation Content 1. Unpacking and Checking........1 2.1 Charging the Battery Unpack the radio carefully. We recommend that 2. Preparation............2 you check the radio and the supplied accessories Plug the adapter into an 2.1 Charging the Battery........2 listed in the following table before discarding the Power applicable AC outlet and... -
Page 5: Installing/Removing The Battery
After about 3~4 hours of charging, the red LED will 2.2 Installing/Removing the Battery Removing the Battery: Do not recharge the battery if it has been fully charged be out, and the green LED will light up, which To remove the battery pack, push the release latch or the radio is not in the low battery alarm state;... -
Page 6: Installing The Antenna
A. LED Indicator 2.5 Installing the Belt Clip 2.3 Installing the Antenna I. Microphone Lights red while transmitting; lights green while J. External Speaker/Microphone Jack Match the two holes of the Hold the bottom of the receiving; flashes red when the radio is in low External speaker/microphone can be connected to belt clip with those on the rear antenna and turn the antenna... -
Page 7: Functions Of Programmable Buttons
4.2 Adjust Volume 5. Functions of 4.4 Make a Call Function Description Programmable Buttons Press the preprogrammed To make a call, select Press the preprogrammed “Squelch Off ” button to hear the desired channel, Lone Worker “Lone Worker” button to The dealer can assign one of the following background noise. -
Page 8: Auxiliary Functions
a) The pre-alert will sound before the TOT action. 6. Auxiliary Functions Function Description Function Description b) After the pre-alert tone, the timer will action you can receive signals that If the radio stays at a noise 6.1 TOT (Time-Out-Timer) when the transmitting time has gone beyond the limit. - Page 9 transmit will only be received by parties whose these channels. channel, it will stay at the priority channel; if there is 6.3 Low Battery Warning CTCSS/DCS tones are the same as yours. no signal, it will return to the original channel. 6.7.1 Starting/Stopping Scan When the battery voltage drops too low, the LED Note:...
-
Page 10: Wired Clone Mode
When pressing the PTT button during the scanning button) or any button (if any button is designated as The operating steps go as follows: scan list cannot be deleted. pause, the radio will transmit from the currently the lone worker timer reset button) to restart the lone 1. -
Page 11: Troubleshooting
A. The frequencies of both users are not the same. Please select the same frequency channel again. Cannot transmit General Specification PT578 B. The CTCSS/DCS signals of both users are not the same. Please reset it. 136-174MHz, VHF C. The radio is out of effective communication range. -
Page 12: Fcc Notice
You can cause the radio to transmit by pressing the RF exposure levels exceeding the FCC requirements Power supply DC7.4V In addition, your KIRISUN radio complies with the “PTT” switch. for wireless RF exposure. following Standards and Guidelines with regard to RF ALWAYS keep the antenna at least 2.5 cm (1 inch) - Page 13 10 cm (2 to 4 inches) away from the lips and the FCC CAUTION: Changes or modifications to this sensitive to electromagnetic radiation such as If disregarded,inconvenience only.No transceiver is vertical. device, not expressly approved by KIRISUN, could NOTE hospitals, aircraft, and blasting sites. risk of personal injury,fire or electric WARNING!
- Page 14 DECLARATION OF CONFORMITY NOTE： NOTE： NOTE： We, Shenzhen Kirisun Electronics Co., Ltd. 3-6Flrs,ROBETA Building, No. 1, QiMin Road, Song Ping Shan Area, Science & Industry Park,Nanshan District Shenzhen 518057 P.R.China Declare on our sole responsibility that this equipment complies with the essential requirements of the Radio and...
Need help?
Do you have a question about the PT578 and is the answer not in the manual?
Questions and answers