Interval Between Vise And Guide Plate; Setting For Desired Cutting Angle - Makita 2414B Instruction Manual

Interval between vise and guide plate
The original spacing or interval between the vise and the guide plate is
0
-
170 mm
(0
-
6-11/16"). If your work requires wider spacing or interval, proceed as follows to change
the spacing or interval.
Remove the two hex bolts which secure the guide plate. Move the guide plate as shown
in the figure and secure it using the hex bolts. The following interval settings are possible:
35
-
205 mm (1-3/8" - 8-1/16")
70 - 240 mm (2-3/4" - 9-7/16")
----E?=
Hex bolts
CAUTl ON:
Remember that narrow workpieces may not be secured safely when using the two, wider
interval settings.
Setting for desired cutting angle
To change the cutting angle, loosen the two
hex bolts which secure the guide plate. Move
the guide plate to the desired angle ( 0 ' -
45') and tighten the hex
bolts
securely.
Socket wrench
CAUTION :
Never perform miter cuts when the guide plate is set at the 35
-
205 mm (1-3/8" - 8-1/16")
or
70
- 240 mm (2-3/4" - 9-7/16") position.