Download Table of Contents Print this page
Makita 2414NB Instruction Manual

Makita 2414NB Instruction Manual

Portable cut-off
Hide thumbs Also See for 2414NB:


Portable Cut-Off
IMPORTANT: Read Before Using.


Table of Contents

Summary of Contents for Makita 2414NB

  • Page 1 INSTRUCTION MANUAL Portable Cut-Off 2414NB 006184 DOUBLE INSULATION IMPORTANT: Read Before Using.
  • Page 2: Specifications

    ENGLISH (Original instructions) SPECIFICATIONS Model 2414NB Wheel diameter 355 mm Hole diameter 25.4 mm No load speed (min 3,800 Dimensions (L x W x H) With under cover 500 mm x 280 mm x 620 mm Net weight With European type safety guard and under cover 18.4 kg...
  • Page 3 Do not force the tool. Makita Corporation responsible It will do the job better and safer at the rate for manufacturer declare that the following Makita which it was intended. machine(s): Use the right tool. Designation of Machine: Do not force small tools or attachments to do the Portable Cut-Off job of a heavy duty tool.
  • Page 4: Additional Safety Rules For Tool

    18. Use outdoor extension leads. 10. Make sure the wheel is not contacting the When tool is used outdoors, use only extension work-piece before the switch is turned on. cords intended for outdoor use. Before using the tool on an actual workpiece, 19.
  • Page 5: Installation

    Spark guard INSTALLATION Securing cut-off 1. Screw 2. Spark guard 1. Base 2. Bolt holes 003756 The spark guard is factory-installed with its lower edge contacting the base. Operating the tool in this position 003800 This tool should be bolted with two bolts to a level and will cause many sparks to fly around.
  • Page 6: Securing Workpiece

    Setting for desired cutting angle 1. O-ring 2. Inner flange 1. Socket wrench 3. Ring 2. Guide plate 4. Spindle 3. Hex bolts 5. Cut-off wheel 6. Outer flange 7. Hex bolt 003762 CAUTION: 003760 Be sure to tighten the hex bolt securely. Insufficient To change the cutting angle, follow the procedure below: •...
  • Page 7: Operation

    OPERATION 1. Spacer block Hold the handle firmly. Switch on the tool and wait until the wheel attains full speed before lowering gently into the cut. When the wheel contacts the workpiece, gradually bear down on the handle to perform the cut. When the cut is completed, switch off the tool and WAIT UNTIL THE WHEEL HAS COME TO A COMPLETE STOP before returning the handle to the fully elevated position.
  • Page 8: Optional Accessories

    Fold down the tool head to the position where you can If you need any assistance for more details regarding attach the chain to the hook on the handle. these accessories, ask your local Makita Service Center. Abrasive cut-off wheels MAINTENANCE •...
  • Page 12 Makita Corporation Anjo, Aichi, Japan 884151H221...

Table of Contents