Fig. 4-5
Remove Retaining ring S-8 (87) and Retaining ring
5)
S-16 (90) with 1R291.
Retaining ring S-16 (90)
Retaining ring S-8 (87)
1R291
5-3-5 Guide plate
5-3-5-1 Disassembling (LW1400's case)
Fig. 5-1
Loosen Knob 40 (72) and then
1)
remove Guide plate (73) from
Base (86).
Knob 40 (72)
Guide plate (73)
Pin 16 (89)
Vise plate (92)
Fig. 5-2
Remove Lever 125 (101) by
2)
loosening M5x6 H.S.Set screw
(100). Then remove M10x20
Collar bolt (71).
M5x6 H.S.Set
screw (100)
M10x20 Collar
Makita Corporation
Fig. 4-6
The components of Vise ass'y (119) is as follows.
6)
Note: Be careful of the direction for each part.
Flat washer 8 (88)
wide
3)
Note: Be sure not to lose Stop ring.
Lever 125 (101)
bolt (71)
Pin 16 (89) has
to be assembled
as shown in the
figure on the
left.
Flat washer 8 (91)
narrow
Fig. 5-3
Remove Stop ring E-8 (110) with
a slotted screwdriver like turning
and prying it.
9 / 15