Winnebago Journey Owner's Manual page 105

Electric Water Heater Switch
(Typical)
For LP Gas Operation: Press the Water
Heater switch on the Monitor Panel. The "Pilot
Out" light will glow for about 10-15 seconds,
then it will go out. The "Heater On" indicator
will remain lit. If the "Pilot Out" light comes on
during LP operation, it means that the burner has
gone into "lockout" mode and must be restarted.
If this happens, turn the Water Heater switch off
for about 5 minutes, then turn it back on. See the
Atwood user's guide in your Owners InfoCase
for further information.
Water Heater Switch and
"Pilot Out" Indicator
Be sure the water heater is filled with water
before pressing this switch. To fill the water heat-
er, turn the water pump switch on and open a hot
water faucet until water begins to flow.
APPLIANCES & INTERIOR FEATURES
For Quick Recovery Operation (Dual):
Turn On both Water Heater switches; the gas one
on the monitor panel and the electric one. This
will help reheat the water heater tank more
quickly than a single source would alone. Use
this mode when you are using a larger than nor-
mal volume of hot water, for example, when
someone is taking a shower and the dishwasher
or clothes washer is also being used.
Gas Safety Information
A. This appliance does not have a pilot light. It
is equipped with an ignition device that auto-
matically lights the burner. Do Not try to
light the burner by hand.
B. Before lighting, smell around the appliance
area for gas. Be sure to smell near floor
because LP gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Get out of the coach immediately and turn
off the LP gas tank at the main tank valve.
(See photo on page 5-2.)
• Use a neighbor's phone to call your Win-
nebago Industries dealer or a local gas sup-
plier for instructions. Do not use a phone in
your coach. Follow the dealer's or gas sup-
plier's instructions.
• If you cannot reach a Winnebago Industries
dealer or a local gas supplier, call the fire
department.
• Have the source of the leak corrected before
using the LP gas system again.
Operating Instructions
1. STOP! Read the safety information provided
in the Atwood Water Heater Operation Man-
ual in your Owners InfoCase.
2. Turn off water heater power switches.
3. Turn LP gas supply off.
4. Wait five minutes for any gas to clear the
area. If you smell gas, then stop and follow
item B of the Safety Information above. If
SECTION 8
8-11