Winnebago Journey Owner's Manual page 50

SECTION 2
DRIVING YOUR MOTOR HOME
Front Slideout Room Emergency Crank-In
Procedure (Use only when slideout room will
not retract using control switch)
If a failure occurs in the slideout electrical or
hydraulic systems, and the room will not retract
using the control switch, you can manually crank
the room in using an emergency winch system
described below. The winch is stored in a cargo
compartment on the passenger side of the coach.
Step 1 - Relieve Hydraulic Line Pressure
· Open the hydraulic pump slideout solenoid-
valves to release hydraulic line pressure and
let fluid bypass into the fluid reservoir. The
pump is located behind an access cutout in
the large cargo compartment below the slide-
out room on the driver side of the coach.
WARNING
Stop engine, place transmission in
park position and apply parking brake
before lying beneath vehicle for this
procedure.
NOTE: The hydraulic pump is equipped with two
types of hydraulic solenoid valves
shown. The leveling jack solenoids have
a T-handle on the valve shaft that can be
turned by hand. The slideout room sole-
noid has a small 1/4" nut at the end of
the valve shaft that requires you to use a
1/4" nut driver tool that is provided in
your InfoCase.
2-26
See the HWH Operator's manual includ-
ed in your InfoCase for specific instruc-
tions on which valves to open for front or
rear slideout rooms and what additional
precautions to follow.
· Open the two slideout solenoid valves (with
1/4" nuts on the ends) on the motor end of the
pump to relieve hydraulic line pressure. (See
Step 1 under "slideout Room Emergency
Crank-In" on previous page.) DO NOT
LOOSEN NUTS MORE THAN 4 FULL
TURNS.
Use provided 1/4" nut driver to turn nut
counterclockwise 4 turns only.
Slideout Room Solenoid Valve
· Do not open any of the four large T-handled
valves on the opposite end of the pump.
These regulate the coach leveling jacks.
Leveling Jack Valves - Do Not Open