S Sideguard Hardware; Check-Out - Quickie QXi Owner's Manual

Q Xi
s. siDEgUARD hARDWARE (optional)
1. installation of side guard hardware
a. Position outer receiver hardware (A) on frame.
b. on corresponding inside of the frame position inner clamping hardware (B)
c. insert two bolts (c) with washer(E)and tighten using 3/16 inch hex key
d. Your sideguard (D) can now be inserted into the receiver.
notE –After installing receiver hardware and inserting side guard check for interference. Don't operate the
wheelchair that as interference with these other components.
t. chEck-oUt
After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also
perform smoothly. if you have any problems, follow these procedures:
1. Review the set-up and check-out sections and operating guide to make sure chair was properly pre-
pared.
2. Review troubleshooting guide.
3. if your problem persists, contact your authorized supplier. if you still have a problem after contacting
your authorized supplier, contact sunrise customer service. see the introduction page for details on
how to contact your authorized supplier or sunrise customer service.
120346 Rev. B
55
26
D
c
E
B
55