Sideguard; Storage Tips; Inspect - Quickie GP Series Owner's Manual

ENGLISH
19
N. SIDE GUARD
Inserting and Removing the Side Guard
a. Insert the Side Guard into Side Guard outer receiver hardware
b. To Remove, grip the top of the Side Guard and pull upward.
NOTE – After installing receiver hardware and inserting the side guard, check for interference. Don't operate
the wheelchair if the sideguard interferes with any of the other components.
O. STORAGE TIPS
1. Store your chair in a clean, dry area. If you fail to do so, parts may rust or corrode.
2. Before using your chair, make sure it is in proper working order.
3. Inspect and service all items on
4. If stored for more than three months, have your chair inspected by an authorized dealer
before use.
P. INSPECT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should
also perform smoothly. If you have any problems, follow these procedures:
1. Review the set-up and check-out sections and operating guide to make sure chair was properly
prepared.
2. Review the troubleshooting chart at the beginning of this section.
3. If your problem persists, contact your authorized dealer. If you still have a problem after contacting
your authorized dealer, contact Sunrise customer service. See the Introduction Page for details on how
to con-tact your authorized dealer or Sunrise customer service.
the "Safety checklist".
VIII. USE AND MAINTENANCE
19
19
MK-100309 Rev. B