Zone Initial Setting - Fujitsu UTY-RVNYN Installation Manual

9.6. Zone initial setting

Enable items for zone initial setting are displayed.
system according to the installation conditions.
Incorrect settings can cause the indoor unit to malfunction. This procedure
should be performed by authorized installation or service personnel only.
Perform the "ZONE INITIAL SETTING" according to the installation condi
tions using the remote controller.
Perform the setting during the operation is stopped.
[Enter button].
Service 2/2 Mo 10:00
[ ]
Zone initial setting
Back Setting:
-Note-
Settings are being confirmed.
and turn it on again.
9.6.1 Number of outlets
Set the number of outlet.
Select [Number of outlets] with pressing the [Cursor button (Up/
1
Zone initial setting
Number of outlets
Damper type setting
Connection state of op. sensor
Temperature sensor setting
Zone function setting
Back
Version
2
[Enter button].
Number of outlets
1
Zone Zone
1 0
5
Zone Zone
0 0
Cancel:
-Note-
Not the all the setting value cannot be set to "0".
and "Weekly timer setting" will be updated. Make sure to inform the user
Zone initial setting Mo 10:00
Number of outlets
Damper type setting
Connection state of op. sensor
Temperature sensor setting
Zone function setting
Back Setting:
Version Function setting
Mo 10:00
Setting:
Function setting
2 3 4
Zone Zone
0 0
6 7 8
Zone Zone
Common
0 0 0
OK:
9.6.2 Damper type setting
Set when you use spring return damper.
Select [Damper type setting] with pressing the [Cursor button (Up/
1
Zone initial setting
Number of outlets
Damper type setting
Connection state of op. sensor
Temperature sensor setting
Zone function setting
Back
Version
Switch the damper type "Not in use" or "In use" with [Cursor button
2
Damper type setting
Cancel:
Number of ou...
-Note-
If a spring return damper is installed and this setting is changed to "In
minute." is displayed on the screen for about 1 minute.
Monitor
Mode Set temp.
26
Cool
Operation will commence in a minute.
Menu
9.6.3 Connection state of op. sensor
Set when you use optional sensor.
Select [Connection state of op. sensor] with pressing the [Cursor but
1
Zone initial setting
Number of outlets
Damper type setting
Connection state of op. sensor
Temperature sensor setting
Zone function setting
Back
Version
2
Connection state of op. sensor
Optional sensor 1
In use
Cancel:
Damper type...
-Note-
and "Weekly timer setting" will be updated. Make sure to inform the user
Mo 10:00
Setting:
Function setting
Mo 10:00
Spring return
damper
Not in use
OK:
Connection s...
Mo 10:00
Fan
° C
Auto
Zone ( single )
Mo 10:00
Setting:
Function setting
Mo 10:00
Optional sensor 2
Not in use
OK:
Temperature...
10