Setting The Room Temperature Detection Location; Without Zone Control; With Zone Control - Fujitsu UTY-RVNYN Installation Manual

10. SETTING THE ROOM TEMPERATURE
DETECTION LOCATION

10.1. Without zone control

The detection location of the room temperature can be selected from the
following 2 examples. Choose the detection location that is best for the
installation location.
Refer to "9.2. Function setting".
A. Indoor unit setting (factory setting)
The room temperature is detected by the indoor unit temperature sensor.
function (Function Number:42)" to "No(00)".
A
B. Indoor unit/remote controller setting (room temperature sensor
selection)
The temperature sensor of the indoor unit or the remote controller can be
used to detect the room temperature.
function (Function Number:42)" to "Yes(01)".
(1)
will be described later.
(2) Select either of the temperature sensor on the indoor unit or on the
B
CAUTION
value between the temperature sensor of the indoor unit and the tempera
to the control status of temperature sensor of the indoor unit temporarily.
As the temperature sensor of remote controller detects the tempera
temperature correctly sometimes. Especially when the outer side of the
recommended to use the temperature sensor of the indoor unit to detect
the room temperature when the indoor and outdoor temperature differ
The temperature sensor of the remote controller is not only used when
there is a problem in the detection of the temperature sensor of the indoor
unit.
1 ) Indoor room temperature sensor switching function
(Only for Wired remote controller)
The following settings are needed when use the control by Wired remote
controller temperature sensor.
Setting Description
No
Yes
* If setting No. is "00" :
Room temperature is controlled by the indoor unit temperature sensor.
* If setting No. is "01" :
Room temperature is controlled by either indoor unit temperature sensor
or remote controller unit sensor.
Indoor unit
Indoor unit
( ...Factory setting)
Function No. Setting No.
00
42
01
2 ) Setting record
Record the setting change in the following table.
Setting Description
Indoor room temperature
sensor switching function
and turn it on again.

10.2. With zone control

The detection location of the room temperature can be selected from the
following 2 examples. Choose the detection location that is best for the
installation location.
Refer to "9.2. Function setting".
A. Indoor unit setting (factory setting)
The room temperature is detected by the indoor unit temperature sensor.
function (Function Number:42)" to "No(00)".
A
B. Indoor unit/remote controller/optional sensor setting (room tempera-
ture sensor selection)
optional sensor can be used to detect the room temperature.
function and room temperature control switching (Function Number:42
and 48)" to "Yes(01)".
(1)
will be described later.
(2)
described later.
(3)
which will be described later.
(4)
B
Indoor unit
CAUTION
As the temperature sensor of remote controller or optional sensor detects
the room temperature correctly sometimes. Especially when the outer
side of the wall on which the sensor is positioned is exposed to the open
detect the room temperature when the indoor and outdoor temperature
Setting No.
Indoor unit
interface
interface
Optional
sensors
12