8. CYLINDER HEAD/VALVES
CYLINDER HEAD
REMOVAL/INSTALLATION
*
Always replace the camshaft holder and
cylinder head in pairs
Remove the camshafts (refer to the
"CAMSHAFT REMOVAL/INSPECTION/
INSTALLATION" section in this chapter)
Remove the two bolts and intake pipe.
Remove the five bolts, then remove the pair
reed valve cover and holder.
Remove the two nuts, then remove the pair
reed valve and gasket.
Remove the two bolts, water joint, gasket and
water stop collar.
8-17
Pair Reed Valve Cover/Holder
Water Joint/Gasket/Water Stop Collar
MXU 500
Intake Pipe
Gasket