Main Brush And Floor Brush - iNFinuvo Hovo 510 User Manual

Tip: Sometimes, the rubber cleaning head might fall off when you clean the dust bin.
Please follow the instruction below to re-install it.
Rubber
cleaning
head
Fig. 1
1. Put the dustbin and rubber cleaning head in position as shown in Fig. 1.
2. Place one side of the cleaning head into the dustbin first; make sure the cleaning head is
upward and connect well with the dustbin. (see Fig. 2).
3. Let cleaning head completely connect to the dustbin by pressing it down with hand.
Install & Removal of Main Brush & Floor Brush:
1. Push the red locking latch on brush holder
forward, so you can lift the holder up and
open it. Lift the main brush from this side,
and pull it out from the mounting hole other
the other side (see Fig 1 and Fig 2)
2. Take out both main brush and floor brush
in this way. (see Fig 3)
3. Insert new main brush and floor brush
to mounting holes, then close the brush
hold assembly.
Install & removal of Side Brush:
1. Remove side brush mounting screw first, then take out the side brush.
2. Press the new side brush against the main shaft, and
then fasten the screw. (see Fig. 4)
Fig. 2
Fig.1
Fig. 4
-14-
Fig. 3
Fig.2
Fig.3