Charging Station - iNFinuvo Hovo 510 User Manual

Charging Station：
Tips: Before you use the charging station, code check is required. Otherwise, it will not work.
Code check steps:
A: Turn off the cleaner;
B: Press and hold the code check button of docking station; (Tip: code check button
is inside a hole, so you need to use a tool to press it down)
C: Turn on the cleaner;
D: After the cleaner beeps 2 or 3 times, release the "OK" button. The code check
is successfully completed now.
★ Note: If you do not hear beeping sounds 2 or 3 times during code check, just repeat above steps.
Tip: It is better to put charging station against the wall, or it might be pushed by cleaner from the
side or back of charging station, which could cause docking troubles.
Automatic Charging:
1. Put the docking station on a hard, leveled surface against the
wall. ( See Fig. 1)
2. No obstacle or hollow area 10 ft away in front of the
charging station, or 2 ft away on the left & right of it.
(See Fig. 1)
3. The cleaner can not find the docking station for
re-charging if the IR infrared signal window
on docking station is covered or blocked.
4. Connect the plug of AC adaptor to the
input socket on charging station. (See Fig. 2)
5. LED indicator status:
A: During charging process, LED indicator light blinks once per
second.
B: In standby status, LED light will change from bright to
dark.
Tip: Press "ALL" button on remote control to turn off the LED light.
indicator
LED
Infrared signal transmitting
window
Code check button
Charging electrode
DC socket
(backside)
Figure 2