Virtual Blocker - iNFinuvo Hovo 510 User Manual

Virtual Blocker:

Power switch
Code check button
Tip: You should perform code check before using Virtual blocker; otherwise it will not work.
Code check steps:
A : Turn off the cleaner first, and turn on the Virtual blocker (with power indicator on);
B : Keep holding the code check button on the Virtual blocker; (Tip: the code check button
is inside a hole, so you need to use a tool to press it down)
C : Turn on the cleaner;
D: After the cleaner beeps 2 or 3 times, release the code check button. The code
check is successfully completed now.
★ Note: If you do not hear the sound 2 or 3 times during the code check process, just
repeat above steps.
Tip : It is better to put virtual blocker against the wall, or it might be pushed by the cleaner from
the side or the back of virtual blocker, which may let the cleaner across the confined area.
Signal transmitting
Power indicator