A Message Appears - Roland Texart RT-640 User Manual

A Message Appears

These are the main messages that appear on the machine's display to prompt correct operation.
They do not indicate any error. Follow the prompts and take action accordingly.
[1 ■ 2 ■ 3 ■ 4 ■ 5 ■ 6 ■ 7 ■ 8 ■]
Ink has run out. Replace the ink pouch indicated by the flashing number with a new pouch.
[PRESS THE POWER KEY TO CLEAN]
This message appears when the machine has been unused for about one month. Switch on the sub power
once a month.
P. 84"When Not in Use for a Prolonged Period"

[CLOSE THE COVER (FRONT COVER, RIGHT COVER, or LEFT COVER]
Close the front, left, and right covers. For safety, the print-head carriage does not operate while a cover is open.
[SHEET NOT LOADED SETUP SHEET]
Load the media. This message appears when an attempt to perform a printing test was made while no media
was loaded.
[EMPTY DRAIN BOTTLE]
This appears when a certain amount of discharged fluid collects in the drain bottle. If this screen appears,
discard the discharged fluid in the bottle.
P. 57"Disposing of Discharged Fluid"

[INSTALL DRAIN BOTTLE]
Check whether the drain bottle is installed. Install the drain bottle, then press
P. 57"Disposing of Discharged Fluid"

[TIME FOR MAINTENANCE]
It is time to clean the printer heads manually. After verifying, press
P. 65"Manual Cleaning"

[TIME FOR WIPER (FELT) REPLACE]
6
It is time to replace the wiper or felt wiper. After verifying, press
P. 76"Replacing the Wiper"

[END OF THE SHEET]
The trailing edge of the media was detected during operation. Press any button on the operation panel to
clear the message. Load new media.
[REMOVE MEDIA CLAMPS]
This message appears if the media clamps are attached when you try to cut off the media. Open the front
cover, remove the left and right media clamps, and press
122
, P. 79"Replacing the Felt Wiper"
.
.
.
.